SHS800 User Manual(V1.3).pdf

(4657 KB) Pobierz
User Manual
SHS800 Series Handheld Digital Oscilloscope
V1.3
SIGLENT TECHNOLOGIES CO,.LTD
Declaration
1. Copyright © SIGLENT TECHNOLOGIES CO., LTD.
2. Information in this manual takes place of all data published before.
3. SIGLENT company reserves the rights to change specifications and price.
4. Contents in this manual are not allowed to be copied, extracted and
translated without permission by the company.
SHS800 Series
I
Safety Information
Carefully read the following safety information before using the SHS800.
Specific warning and caution statements, where they apply, appear throughout the
manual.
A “Warning” identifies conditions and actions that pose hazard(s) to the user.
A “Caution” identifies conditions and actions that the user should notice.
The following international symbols are used on the SHS800 and in this manual:
Hazardous
Voltage
Protective
Earth Ground
Warning
Earth Ground
Power
Switch
Use only insulated voltage probes, test leads and adapters supplied
with the SHS800, or accessories appointed by the company.
Before use inspect voltage probes, test leads and accessories for
mechanical damage and replace when damaged.
Always connect the battery charge first to the AC outlet before
connecting it to the SHS800.
Do not apply voltages that higher than 600 V from earth ground to any
input when using scope ports in a CAT
Ⅲ
environment. Do not apply
voltages that higher than 1000 V from earth ground to any input when
using scope ports in a CAT
Ⅱ
environment.
Do not apply input voltages above the rating of the instrument. Use
caution when using 1:1 test leads because the probe tip voltage will be
directly transmitted to the SHS800.
Do not apply voltages that higher than 300 V from earth ground to any
input when using multimeter ports in a CAT
Ⅲ
environment. Do not
apply voltages that higher than 600 V from earth ground to any input
when using multimeter ports in a CAT
Ⅱ
environment.
Do not apply voltages that higher than 300 V from earth ground to the
isolated inputs when using multimeter ports in a CAT
Ⅲ
environment.
Do not apply voltages that higher than 600 V from earth ground to the
isolated inputs when using multimeter ports in a CAT
Ⅱ
environment.
II SHS800 Series
Do not insert metal objects into connectors.
Use of the SHS800 in a manner not specified may impair the
protection provided by the equipment. Before use, inspect the test
leads for mechanical damage and replace damaged test leads!
Whenever it is likely that the safety has been impaired, the SHS800
must be turned off and disconnected from the line power. The matter
should then be referred to qualified personnel.
Warning:
Standard probe 10:1 supports CAT
Ⅱ
400V.
Optional probe supports CAT
Ⅱ
1000V and CAT
Ⅲ
600V
SHS800 Series
III

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin