How to work with the programmer EZP2010
How to work with the programmer EZP2010. Sewn as normal BIOS, and UEFI.
In this manual, we will consider installing the driver on the programming and firmware BIOS. In addition to the old (Legacy) BIOS firmware will be considered and modern - UEFI. For writing the material was taken motherboard ASUS, the size of the capsule which is 8194 KB. Other manufacturers of this size can vary and edit BIOS file will have a little different. For example, many of ASRock motherboards file size is 8196 KB and "cut" would have been 4 KB. Everything depends on the situation, it is only necessary to correctly identify the title and remove it.
The first part describes how to install the driver. The second part deals with a simple firmware version BIOS. The third part examines the firmware UEFI BIOS.
Part 1: Installing the driver
Connect the programmer to the PC. In Device Manager shows "Unknown Device".
Click on the device, right-click and choose "Update driver software." Select the option "Browse my computer for driver software."
Specify the path to the driver.
To agree with the installation of the driver.
If the driver is established correctly, the following window will appear:
Check in Device Manager correctly install the driver programmer.
If you are using Windows 7 64-bit, it may be a bug with the driver signature verification. In this case it is necessary through the Device Manager to remove the device EZP2010 to remove the driver and disconnect the programmer from the PC. You then need to restart the PC and call options menu boot Windows, where you select "Disable Driver Signature Verification mandatory." When the OS loaded, perform all the steps to install the driver.
Part 2. Firmware usual BIOS
Remove the BIOS chip from the motherboard. Set the lever on the programmer in a vertical position. Set connectors in the BIOS chip on the photo. Observe the position of the key (highlighted in red in the image). Set the lever to the horizontal position. Connect the programmer to the PC. The red LED. Run this program EZP2010.exe. If the programmer found the program in the lower right corner of the window is information about this - «USB Link OK!». Press the «Detect». If the chip is supported, it will be determined by its type. Immediately it is selected in the menu «Select Chip» and no further action is required. Press the «Load», select the file BIOS, click "Open."
Press the «Auto», to start the process of firmware. The flash occurs in three stages. Erasing of the chip. Process in "%" may be displayed.
Writing firmware to the chip. Checking chip. If the firmware is successfully completed, you will log «Verify chip ok!» And time of the firmware. You can remove the chip from the programmer and installed on the motherboard.
...
tomash_21