05055.pdf

(43 KB) Pobierz
2400 BPS Internal Modem
(250-1034)
Settings
Faxback Doc. # 5055
SELECTING A COMMUNICATIONS PORT
Most computers allow two communications ports, Com 1 and Com 2, to identify
the address or location in computer memory of each serial device that is
connected to the computer.
The factory setting is Com 1. If you use a mouse or other serial device,
check its board setting to see which Com port it addresses. If the other
device is set for Com 1, you must change the Com port setting on your modem to
Com 2. If you set two devices to the same address, your modem or the other
serial device does not function properly.
If necessary, before installing the modem, change the Com port setting as
shown below.
If your communications software allows you to select a Com port, be sure to
select the same com port that you selected with the jumpers on the modem.
┌───┐
│
O
│
│
│
│
O
│
└───┘
O
COM 2
O
┌───┐
│
O
│
│
│
│
O
│
└───┘
COM 1
(smm 07/29/93)

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin