20090614231015.pdf

(56 KB) Pobierz
Diagnosis plug
Flash code:
Display activation and operation:
To use the display to show DTCs, the control switch must
be used.
There are four buttons on the control switch which are used
to browse through the menus:
1. " Esc " Used to return to the previous menu or to
interrupt an operation
2. " Select " Confirms a highlighted menu selection
3. " + "
Moves the cursor up
4. " - "
Moves the cursor down
The DTCs have an “FMI” value. This
indicates the fault type on the basis of the
following schedule:
FMI:
0.
Value too high:
Data is
acceptable, but is above the normal working
range
1.
Value too low:
Data is
acceptable, but is below the normal working
range
2.
Incorrect data:
Varying or
incorrect data:
3.
Electrical fault:
Abnormally high
voltage, or short-circuit to higher voltage
4.
Electrical fault:
Abnormally low
voltage, or short-circuit to lower voltage
5.
Electrical fault:
Abnormally low
current, or broken connection
6.
Electrical fault:
Abnormally high
current, or short-circuit
7.
Mechanical fault:
Faulty response
from mechanical system
8:
Mech. or el. fault:
Abnormal
frequency
9:
Communication fault: Abnormal
update rate
10: Mech. or el. fault:
Abnormally
large variations
11: Unknown fault:
Unidentifiable
fault
12: Component fault:
Faulty unit or
component
13: Incorrect calibration: Calibration
value outside limits

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin